HELP!!!! sitting RX7 (5 years)
#1
Junior Member
Thread Starter
Join Date: Jun 2003
Location: Florida
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
HELP!!!! sitting RX7 (5 years)
I just purchased a 1986 GXL RX-7 for $200.00. as is. I tried to start it.....and nothing happen not even a click, put a new battery in. still nothing. any suggestions???
#3
Senior Member
iTrader: (10)
Join Date: Sep 2002
Location: Chicago
Posts: 469
Likes: 0
Received 0 Likes
on
0 Posts
Try putting some MMO(marvel Mystery Oil) in the bottom two spark plug holes only put a few tablespoons in each. then turn the engine by hand a few times to make sure it coats most of the engine. Let it sit for about a day and then try and start it up.
You are going to want to change the oil as well.
What is the condition of the gas in the tank. I mean has that been sitting for five years too. If so you are going to have to deal with thats as well.
Good luck.
Yup, that might be a good idea.
You are going to want to change the oil as well.
What is the condition of the gas in the tank. I mean has that been sitting for five years too. If so you are going to have to deal with thats as well.
Good luck.
PS- PREY!
#4
Junior Member
Thread Starter
Join Date: Jun 2003
Location: Florida
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
I know Praying is the best thing that I can do,but I will also try your suggestion and see if that does the trick where can I purchase this mystery oil???
#7
In Full Autist Cosplay
iTrader: (1)
Join Date: Nov 2002
Location: Alberta
Posts: 2,330
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by FernandezJ
what is the deal with putting 2 stroke engine oil in gas tank???
what is the deal with putting 2 stroke engine oil in gas tank???
After those years. a seal might have gotten stuck to a housing.
Let some MMO soak for a day to break it free, then try to start it.
It should smoke quite nicely after you start it up.
Trending Topics
#8
Village Idiot
iTrader: (8)
putting 2 stroke oil in the gas tank is only for premix, don't worry about that.
Make sure the battery connectors are free of corosion and tightly secured.
Try turning the main (biggest and lowest) pulley with a 19mm socket to make sure the engine is not siezed up, make sure you turn it the direction as if you were tightening the bolt.
Make sure the battery connectors are free of corosion and tightly secured.
Try turning the main (biggest and lowest) pulley with a 19mm socket to make sure the engine is not siezed up, make sure you turn it the direction as if you were tightening the bolt.
#21
Rotary Enthusiast
Join Date: Sep 2002
Location: Daytona beach
Posts: 1,351
Likes: 0
Received 0 Likes
on
0 Posts
#22
Full Member
Join Date: Aug 2002
Location: Sacramento
Posts: 246
Likes: 0
Received 0 Likes
on
0 Posts
there is a bolt at the bottom of the gas tank. Drain all the gas out of the car before you attempt to start. I purchased and FB that had been setting for about the same length of time. Drian all fluids. I was told to use Seafoam, which is about the same as Marvel Mystery Oil. Don't use ATF as it might cause longterm problems.
Let the Seafoam set in over night. What I did was take all the spark plugs out and fan belts and turned the engine by hand first. I would imagine all the brake rotors will be frozen. Normally some liquid wrench and a couple takes with a hammer will losen. But I had to replace two of four. I drained out all the brake fluid, clutch fluid. I mean all fluids. I would also get under the car and check to make sure all your fuel lines and brakes lines are intact.
Let the Seafoam set in over night. What I did was take all the spark plugs out and fan belts and turned the engine by hand first. I would imagine all the brake rotors will be frozen. Normally some liquid wrench and a couple takes with a hammer will losen. But I had to replace two of four. I drained out all the brake fluid, clutch fluid. I mean all fluids. I would also get under the car and check to make sure all your fuel lines and brakes lines are intact.
#24
Originally posted by RouNdaBouT
putting 2 stroke oil in the gas tank is only for premix, don't worry about that...
putting 2 stroke oil in the gas tank is only for premix, don't worry about that...
Thread
Thread Starter
Forum
Replies
Last Post