I am gonna be doing a turbo II swap here on my N/A rx-7, its a motor and comes with a race ECU cant remember the exact name, but it ups the boost, changes air/fuel etc. and im gonna be putting a tougher clutch in and a lighter flywheel, not too light though, and gonna be rebuilding the rear-end so it can handle the added power, but my question comes in, what kind of harness work needs to be done? is it a total pain in the *** or what am i up against.?

 

Welcome...Use the search function, you'll come up with several answers to your questions...If you can read a wiring schematic OK, it shouldn't be too much of a PITA...

 

ok, thanks for your help.

 

title edited to actually have a subject

and you may wish to look at the links in the FAQ for FC (at the top of the FC section) and do some searching (found in the upper corner of the page) as this has been covered quite in depth mulitple times.