2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Help no start

Thread Tools
 
Search this Thread
 
Old Aug 5, 2013 | 08:50 AM
  #1  
FCReXeveN's Avatar
Thread Starter
mmmmm 777777777777777777
 
Joined: Mar 2013
Posts: 21
Likes: 0
From: georgia
Help no start

My 90 n/a wont start. i took the air intake off to swap for a HKS. while i had the MAF unplugged i tried to crank and move the car. it would crank but when i tried putting a load on it it seemed like it flooded out i did the unflooding process and all is good. Now i cant get it to fire off. it will try to turn over but no spark is getting through. I changed the spark plugs about 3 months ago so they are all good already checked all of them . please help.
Reply
Old Aug 5, 2013 | 09:04 AM
  #2  
clokker's Avatar
Cake or Death?
Tenured Member 10 Years
iTrader: (2)
 
Joined: Jan 2007
Posts: 10,249
Likes: 64
From: Mile High
I assume you've plugged the MAF back in?
Reply
Old Aug 5, 2013 | 09:06 AM
  #3  
FCReXeveN's Avatar
Thread Starter
mmmmm 777777777777777777
 
Joined: Mar 2013
Posts: 21
Likes: 0
From: georgia
yea it is i got the HKS in and everything is hooked up properly i dont know but i think i might need a new battery
Reply
Old Aug 5, 2013 | 10:35 AM
  #4  
satch's Avatar
Moderator
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Jun 2005
Posts: 11,738
Likes: 16
From: tulsa,ok.
If the engine was flooded then perhaps the plugs were ruined or in need of cleaning and drying out. If you pulled the spark plug wires at the coil bore and placed the boot near the bore you could test for spark and rule out the plugs as your problem.
Reply
Old Aug 5, 2013 | 10:54 AM
  #5  
FCReXeveN's Avatar
Thread Starter
mmmmm 777777777777777777
 
Joined: Mar 2013
Posts: 21
Likes: 0
From: georgia
im getting 12.5 v from the battery. but when i try the spark test i dont get much of a spark at all im going to try a new battery and see if that is the problem
Reply
Old Aug 5, 2013 | 11:03 AM
  #6  
satch's Avatar
Moderator
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Jun 2005
Posts: 11,738
Likes: 16
From: tulsa,ok.
You also might want to recheck how solid the connection is at the AFM which you previously unplugged. A poor connection will prevent the injectors and coils from working.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
Sep 16, 2018 07:16 PM
ZacMan
Build Threads
4
Sep 19, 2015 09:20 PM
sherff
Adaptronic Engine Mgmt - AUS
5
Sep 12, 2015 12:22 PM
whinin
New Member RX-7 Technical
10
Sep 5, 2015 11:52 PM




All times are GMT -5. The time now is 07:55 AM.