help with my box's
06-12-08, 09:45 PM
#1
Junior Member
Thread Starter
Join Date: May 2007
Location: Redding CA
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
help with my box's
how do i take them out seems kinda simple but i dont want to mess them up is thire any step by step thread i couldent find any of if anyones done it that would help ty
06-12-08, 10:31 PM
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
if you mean the BINS..undo the little plastic carpet hold downs,by using a Flat head screw driver to Pull/pry them out,or you can use Needle nose.Then Open the bins,you Unscrew the Phillips screws inside the box and around it.The Bin wil pull out,.BUT it has a couple Wires that have the Lights on it..Disconnect(Bullet Connectors)..Proceed to lift the carpet,by just Folding it up and Placing it towards the back of the hatch..Once the carpet is lifted(you may have to take the Strip off,by removing the four/five Phillips screws that secure it)this Will expose the fiberglass Shell.the Shell is held on by Five 10 mm Bolts on the Bottom Edge and about Five on the Surface approximately Half way into the hatch..once they are offf,then just Lift the fiberglass shell out..you can Take it out as ONE,but it is actually two pieces,so that is your Choice..anyhow..That is that..Have fun.STYX.
06-14-08, 05:33 PM
#4
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
let me know how it goes,.Pm me..I hope I didn't forget anything..Actually I did..the Lights in the boxes just Turn the Light Holder at the Bin, and they Pop out and off the Bin..the Switch for the lights are the ones with the Bullet connectors.You just pull them and they Disconnect.
Thread
Thread Starter
Forum
Replies
Last Post
[For Sale] Scratch & Dent, Used, and Open-Box Sale!
SakeBomb Garage
Vendor Classifieds
5
08-09-18 05:54 PM