Im swapping a 91 Jspec TII into my 82 rx7

I need to swap the shifter assembly from my old tranny onto the new 87 TII tranny.

I cant get the shifter bushing off the shift rod. Is there a press fit pin or something, there was a lot of grease and **** in there so it was hard to tell

also, TII's have electric speedo senders right, there was a speedo port but no sender. or am i mistaken

also, could someone identify all the wires on this thing.

there is a large sender or switch with 4 wires and a small switch or sender with 2 wires.

please help, I need to finish the tranny by tommorow.

 

come on, i have to get this part done today so I can get my motor in the car.

 

anybody going to help me, or are you just boycotting me because I got a first gen????

 

All FC trannys had mechanical speedo cables, not electric senders.

There are switchs for 5th gear, Neutral, and reverse. As I recall 5th and reverse are in the same switch assembly and neutral is on its own.

Don't know about the shifter assembly that you are trying to replace.

 

I think there's a set of wires for the reverse lights too, right?

 

 

Here is a close-up of the tail end: