I have removed a relay from my heater blower, that was the cause of the blower not functioning. It is located on the side of the blower housing, within a little rubber cover. There are two of these right next to each other. From what I see on around page 98 of chapter 17 of the FSM there should be two. The one nearer the firewall is the defective one I removed.

The part number on the side of this little black relay is as follows:

NIPPONDENSO
056700-7240
12V
Made in Japan

Below that on the white part that secures the relay is the following:

9 E
35

I would appreciate some assistance on where I may obtain a new one of these critters. I would suspect if a new one is available then I should get that rather than try to find a used one.