Ok this is how it started... i have a boost leak and i wasnt sure where it was. so i asked around and someone suggested to me that the Inlet gasket maybe blown? so i bought a new gasket and decided to take the intel off ( the 4 bumpy things under my top mount) After i removed all the bolts and the 6 Vac lines holding it down ( i marked them ofcourse) Accelerator cable ect ect. Checked the gasket and it was fine. so i decided to jus leave the old one and put my engine back together.. Put all of the Vac lines in and i noticed there was 2 places i could place the cable? so i put it on the one closer to the fire wall and i noticed it had a fair bit of slack, so i tighten the cable up. fair enough. then i go to start my car andit kicks over and then jus stalls straight away. I can start my car but i have to keep my foot on the Accelerator and keep the revs up other wise it stalls it doesnt even try and hold idle If anyone could please help me figure this out it would be greatly appreciated.

And by the way the car was running fine before hand
EDIT: Also when i placed the Humps back on i didnt reseal it with gasket glue could this be the problem?
Im also running the stock Computer.

Thanx
DVS_ONE

 

Anyone?

 

Can anyone give me any ideas what could be causing this?