2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Help: Car starts, runs 3-4 seconds, then stalls.

Old Dec 17, 2004 | 12:59 PM
  #1  
desertdog's Avatar
Thread Starter
desertdog
Tenured Member 05 Years
 
Joined: Dec 2004
Posts: 5
Likes: 0
From: phoenix, az
Help: Car starts, runs 3-4 seconds, then stalls.

87 na stock a week ago it just quit on me .....running good down the freeway and it shut down only engine i had lights and all accs. i have put in a new used CAS and ECU replaced several vacumn hosses everything is checking out ok it starts and about 3-4 seconds later it shuts down most it has stayed running was maybe 10 seconds made checker for codes origianlly could not pull codes...replaced ecu gave me a csa code ...replaced csa gave me a tps c ode tryed to adjust it but no.1 i can't get engine warm and i can't get only 1 light to burn i did get two to light up but then i lost those and now no lights on two bulb checker now it starts shuts off in 5 seconds and gives no codes code checker is ok (I think) it lights up when key is on for 3 seconds and lights go outf what is happening that shuts the engine down help me i thought if you have spark, fuel, and compresssion you could make it run well i can't anything would be GREATLY appreciated 1 thing i have not checked compresssion because if it starts i have compression right? neways help me please
Reply
Old Dec 17, 2004 | 02:26 PM
  #2  
DigitalSynthesis's Avatar
Always something...
Tenured Member 05 Years
 
Joined: Aug 2002
Posts: 944
Likes: 0
From: Atlanta, Ga USA
Holy cow, dude. Please for the love of god reformat that so its readable!
Reply
Old Dec 17, 2004 | 02:49 PM
  #3  
J-Rat's Avatar
Alcohol Fueled!
Tenured Member 20 Years
iTrader: (2)
 
Joined: Jan 2002
Posts: 11,093
Likes: 2
From: Hood River oregon
Okay.. Let me get this straight..

You still get the 2 lights when you first turn the key to on? Then they go out?

Try this:

Jumper the fuel pump test connector (yellow plug by the right shock tower). Then try to start. Report back.
Reply
Old Dec 17, 2004 | 03:30 PM
  #4  
wozzoom's Avatar
Rotary Enthusiast
Tenured Member 15 Years
 
Joined: May 2001
Posts: 903
Likes: 1
From: Conyngham, PA
My WAG (wild *** guess):

Fuel filter is clogged
AFM is unplugged
Large vac leak - Check the hoses under the intake tube and the brake booster vac line.

Do you get any error codes with the engine off and the ignition on?
Can you jump the fuel pump relay and hear the fuel running through the fuel rails?

Don't worry about trying to set the TPS. Do that after you get the car running...A bad TPS will not stall the car.
Reply
Old Dec 19, 2004 | 10:57 PM
  #5  
Initial FC's Avatar
Junior Member
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 30
Likes: 0
From: Bumblefuck, PA
I had the same problem...

I had the same problem last year. Someone broke into my car and they stole my intake. You should check the MAF and make sure it's plugged in... unplug it and plug it back in. I don't know how it happened but it was the source to all my problems. My car would start just fine but would shut off in 3-5 seconds. I was getting pissed and I didn't wanna mess with the vaccum lines cause I was inexperienced with them. so Ijust start unplugging one thing at a time.. and that was it....

hope this helps!
Reply
Old Dec 19, 2004 | 11:06 PM
  #6  
RotaryEvolution's Avatar
Sharp Claws
Tenured Member 15 Years
iTrader: (30)
 
Joined: Oct 2003
Posts: 5,107
Likes: 50
From: Central Florida
sounds to me like a plugged up or broken up catalytic converter, remove the O2 sensor and try running the car, it will be loud but if it runs consistently then i would remove the cats and inspect them, one or more may have melted or borken up and plugged up the mufflers or another cat.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Marty RE
Introduce yourself
3
Aug 29, 2015 07:51 AM
gtcd
1st Generation Specific (1979-1985)
30
Aug 19, 2015 02:44 AM
torky007
3rd Generation Specific (1993-2002)
7
Aug 17, 2015 05:14 PM
ashleymiche
Introduce yourself
0
Aug 14, 2015 12:59 PM
baconflavored
SE RX-7 Forum
0
Aug 12, 2015 12:07 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 01:51 AM.