Header Flange Dimensions
12-17-10, 08:59 PM
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
The flange for the engine side(to manifold)?
Racing Beat make a flange.
You can just trace a Manifold surface onto Gasket paper for the Dimensions..
Better yet just us a Exhaust manifold gasket and copy it,If you are making them from Scratch.
Racing Beat make a flange.
You can just trace a Manifold surface onto Gasket paper for the Dimensions..
Better yet just us a Exhaust manifold gasket and copy it,If you are making them from Scratch.
12-18-10, 12:11 AM
#3
Been here since dirt...
Join Date: Jan 2009
Location: AZ
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
I made a copy of a header flange on a basic copier and the water jet company turned it into a *.dxf with no problem , then cut my flanges from .375" 304 stainless for cheap. MOst good waterjet companies can do this. Don't sweat it.
GD
GD
12-20-10, 07:43 AM
#7
Full Member
Thread Starter
Join Date: Jan 2010
Location: Green Bay, Wisconsin
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
