hard start and leaking coolent !
#1
Brrap braapp..
Thread Starter
hard start and leaking coolent !
=( ... i havnt drove my car for a couple of days since it was hard to start .... then today i came home from work decided to give it a try... it started but... then i see white smoke coming from where my turbo was smelled like coolent ..turned it off and spotted two puddle of coolent between the block and the lim ..took off the uim and looked around but cant find any leak ...could it be my block that is leaking? ..i hope to god no...but this sucks ....cause this was a rebuild from akins rotary with stage two street port...i only put about 3500 miles on it anyone have any ideas.? well
#2
Brrap braapp..
Thread Starter
i took a closer look it tooks like its coming from the lower intake manifold where it connects to the block ......but im not sure its pretty dark outside and i only have a flash light lol .... is there sappose to be coolent there.? ..damn and if its really coming from there that means i have to remove the turbo then get to it ... aww man this sux ....
#4
It's probably the coolant orings between the block and lower intake manifold. Take off your lower intake manifold and inspect. IF you have to replace orings then isntall a new LIM gasket and factory orings. Use a tiny small amount of (gasket sealer I use honda bond) to make the orings stick to the block. Then install LIM gasket then LIM and whala
#5
Brrap braapp..
Thread Starter
yea i am pretty possitive that its my o rings and seals ....they look soaked .....and thanks =) !!! freemanrx7 and jg1bad10th... ill just order the parts tomarrow and work on it sat ...since i have work tomarrow ... dam this is gunnah suck ... LOL having to remove the turbo .. and the heat plates just to get to the lim..oh well heres my chance to change the injector o-rings ......any inputs on what eles i should replace while the uim and lim and turbo is being pulled out... ? oh yea all emssion is removed ported wategate too... and since down pipe is also coming out.. i might as well get my wide band bung welded in there lol ...hmmph
#6
yea i am pretty possitive that its my o rings and seals ....they look soaked .....and thanks =) !!! freemanrx7 and jg1bad10th... ill just order the parts tomarrow and work on it sat ...since i have work tomarrow ... dam this is gunnah suck ... LOL having to remove the turbo .. and the heat plates just to get to the lim..oh well heres my chance to change the injector o-rings ......any inputs on what eles i should replace while the uim and lim and turbo is being pulled out... ? oh yea all emssion is removed ported wategate too... and since down pipe is also coming out.. i might as well get my wide band bung welded in there lol ...hmmph
While your at it you could get hi temp paint and paint everything(LIM,` UIM, clean small parts).
You don't have to remove the turbo to get at the LIM!
Also buy new cooper orings for the OMP injectors.
If you want to replace the injector orings now would be the time.
Also replacing the small hose's(coolant and vac)` would also be good. Use zip ties on these.
I bought some inexpensive ebay heat wrap for my downpipe. I also sprayed it with some sealant.
Replace the pulsation dampner IF you have an s4.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM