Hi,
Im on LaRazaUnidas sn(his friend) but had a question. I just got an 86 NA Rx7 for a trade....I traded a beat up dirt bike that cost less than 100bux. Well that should tell you the condition of the 7. The secondary injectors are leaking and was going to replace them with GSL-SE injectors. Will that run too rich, and too big of a 3800rpm hesitation? If I do go with the SE injectors, would I need to get a chip? I know that rtek does not make NA chips so what would I do?
Thanks for any help.

 

yes the gsl se injectors will make it run rich if the injectors are leaking from the O rings, you may as wel just get a new o ring kit. either way your gonna need new o rings

 

Ok, so I should skip on the SE injectors? One of my secondary injectors leaks, the other I do not even think has gas being pushed through.

 

if the injectors them selves arnt cracked they dont need replacing. just new seals. it sounds like you need to get them profesionaly cleaned. that may help your hesitation as well

 

well...right now Im trying to get the dang thing started!
Like I said its rough. It turns, but it loses so much fuel from the injectors that it doesnt get what it needs to make it run. I will look for an o-ring kit, can I pick one up at Autozone?

I had mentioned the hesitation as a question if I was to replace them with good running SE injecotrs. Srry about the mix up.

 

SE injectors are 680CC, stock NA are 460. The SE injectors are much too large.