Can some one give me the specs on the S4 shifter so that I could figure out if the greddy counter-wight **** would fit.

Thanks.

 

I ordered one.. for the Mazda.. and it doesn't fit.. the hole is to big on the shift ****.. so unless they screwed up and sent me the wrong one (despite part numbers matching) I'm going to just say no.

 

I have the older model GReddy weighted shift **** and it fits fine on my 89 and old 93.

 

Darn, that really sucks.

 

Hey for the heck of it I e-mail GReddy and I didnt really get a response back. Ill copy my Q and GReddy's A below.

(Me)
Hello,
Will the GReddy Counter-Weight Shift **** for Mazdas ( Part #14520561) fit a 1988 Mazda RX-7 N/A. Thank you

~Anthony

________________________________________
(GReddy)
I do not see a reason why not. That **** is for a shift lever with a thread pitch of M10 P1.25, so if you find out if your shift lever's pitch you can verify whether or not our **** will fit.
_________________________________________

They kinda gave me an answer, I knew of the stats M10 P1.25 but that didnt really help me becuase I dont know what the S4 shifter stats are. If anyone knows what the shifter stats are, or if this will fit, plz let me know. Thanks

 

well this sounds kinda chiwi but i have done this and it works awsome. first wipe the shifter shaft down with wd40. then take a hot glue gun and pump two good pumps of glue into the **** hole. then jam the **** on in the desired position allow glue to dry and walla. when you need to remove it give it a good hard twist and its off.

 

haha

- James