Howdy folks. So, I have a 1991 NA car, and I need to install a relay on it to run some electronics. I would like to drive the relay from a 12v switched source.

I can't make a great connection with the pin in the test plug that purportedly is ignition switched (dont have a mating plug, and electrical tape doesnt want to stick...), so are there any other good circuits that would be easy to tap into under the hood?
I thought I might be able to do it from the EGI fuse... turns out I was wrong!

Thanks,
Andrew

 

ahh i can't remember, but i think its the yellow wire on the leading coil. is switched 12v, let me double check

 

I knew I had a post on this. I correct myself: Its a tan wire, not yellow.

https://www.rx7club.com/forum/showth...t=switched+tan

 

Terminate your wire with a male spade terminal and simply plug it into the correct pin on the plug. It doesn't get any easier.