Gauges ..what type and location..
#1
Retired Moderator, RIP
Thread Starter
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
Gauges ..what type and location..
I bought an 1986 Gx with a 13b N/A..I would like to put some gauges on it to monitor the oil pressure. and water temp. can anyone give me info as to what guages to use and where the location of the sendor or sensors would be to swap or put in?..best type(mech oil sender,electrical?..) appreciate anything you gentlemen can send..thanks in advance..misterstyx69
#2
I
iTrader: (6)
you have these gauges stock?, the stock senders for both, are located under the oil filter area,
you have a brass coloured mushroom shaped thing which is the stock oil pressure sender,( you could use a T fitting and tap an aftermarket in there as well....
then the stock temp sender is a small single conector, with a yellow wire with a red stripe( something yellow anyway...)
you have a brass coloured mushroom shaped thing which is the stock oil pressure sender,( you could use a T fitting and tap an aftermarket in there as well....
then the stock temp sender is a small single conector, with a yellow wire with a red stripe( something yellow anyway...)
Thread
Thread Starter
Forum
Replies
Last Post
24seven_dada
3rd Generation Specific (1993-2002)
20
11-10-18 12:03 PM
t-von
3rd Generation Specific (1993-2002)
9
09-10-15 01:56 PM
The1Sun
1st Generation Specific (1979-1985)
0
09-07-15 10:21 PM