Full RB and airpump
#1
Senior Member
Thread Starter
Join Date: Jul 2001
Location: Houston, TX
Posts: 555
Likes: 0
Received 0 Likes
on
0 Posts
Full RB and airpump
I just got my full TII RB exhaust the other day and in reading the instructions i found airpump removal. Is this nessecary?? can i disconnect it and leave it there?? I am assuming that im gonna need it to pass emissions, so i know i will need to reconnect it for emsissions. I just want to know what i need to do to install the exhaust, and also to pass emissions.
Thanks
Thanks
#2
Rotary Freak
Join Date: Mar 2001
Location: LA.,California USA
Posts: 1,611
Likes: 0
Received 0 Likes
on
0 Posts
I have the same exaust system in my TII and i love it!..There is no way you will pass smog with that because it only has one cat!...I did speak with JIM at MAriahMotorsport and he said something like leave the RB catback section and put the only parts from catback all the way to the turbo and you will pass smog. I dont know if you know what im talking about. YOu might want to contact them or RacingBeat and they will tell you what you need to do.
The airpump can stay but you have to tie the split air pipe somewhere or you can disconnect it!..this is the pipe that runs from airpump all the way to your factory exaust system. I would disconnect it though.
Hope this helps a bit..
The airpump can stay but you have to tie the split air pipe somewhere or you can disconnect it!..this is the pipe that runs from airpump all the way to your factory exaust system. I would disconnect it though.
Hope this helps a bit..
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Group Buy & Product Dev. FD RX-7
7
03-21-18 11:19 AM
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
09-11-15 03:29 PM