stevensimon

iTrader: (11)

i started a jdm t2 swap on my fc like last august. pulled the na motor, cleaned everything up, rebuilt the jdm motor, modified the motor and all that jazz. so i finally got to drop it in lastnight and ill be damned if i forgot which injector clips go to which injectors. my setup is jdm motor low impedence injectors usdm t2 harness for low imp. the first two clips go to the primary inkectors but which one goes to which injector? longer pigtail to rear rotor? and then the other injector clips that are at the end of the harness... same thing. longer pigtail goes to which injector? also is there any more modifications that i have to do to the wiring to make everything work correctly? is there a knock sensor plug on the usdm harness? i cant find it. thanks for everyones help in advance.

stevensimon

iTrader: (11)

nobody knows?

RotaryEvolution

iTrader: (30)

the short harness goes to the front rotor and the longer one with the air temp and TPS sensor on it goes to the rear rotor, short leads to primary, longer to secondary. if the plugs in the harness fit the lug in the injector then no modifications are necessary. the knock sensor comes off near where the air temp and TPS connectors split off the rear injector harness, the wire tends to break off flush with the harness due to age.

stevensimon

iTrader: (11)

thank you