fuel cuts and high idle
fuel cuts and high idle
first off my car is warmed up and its nice and warm outside. but anyway i was driving around for a good hour or so and ive been getting bad fuel cuts in the upper range of my car, im thinking its the fact that my turbo is about to take a **** but any other opinions would be nice
edit: its only when im not hitting 10 psi or higher which i dont want to do at the moment with the dying turbo
it can start as low as 4500 and normally starts as high as 6k
also my idle is stuck at the 1500 mark
any ideas on how to fix that? its only been doin that since i put on my fmic and it seems intermittent the wire going to the sensor is fine but maybe the sensor is dead?
edit: its only when im not hitting 10 psi or higher which i dont want to do at the moment with the dying turbo
it can start as low as 4500 and normally starts as high as 6k
also my idle is stuck at the 1500 mark
any ideas on how to fix that? its only been doin that since i put on my fmic and it seems intermittent the wire going to the sensor is fine but maybe the sensor is dead?
first off my car is warmed up and its nice and warm outside. but anyway i was driving around for a good hour or so and ive been getting bad fuel cuts in the upper range of my car, im thinking its the fact that my turbo is about to take a **** but any other opinions would be nice
edit: its only when im not hitting 10 psi or higher which i dont want to do at the moment with the dying turbo
it can start as low as 4500 and normally starts as high as 6k
also my idle is stuck at the 1500 mark
any ideas on how to fix that? its only been doin that since i put on my fmic and it seems intermittent the wire going to the sensor is fine but maybe the sensor is dead? 
edit: its only when im not hitting 10 psi or higher which i dont want to do at the moment with the dying turbo
it can start as low as 4500 and normally starts as high as 6k
also my idle is stuck at the 1500 mark
any ideas on how to fix that? its only been doin that since i put on my fmic and it seems intermittent the wire going to the sensor is fine but maybe the sensor is dead? 
Thread
Thread Starter
Forum
Replies
Last Post
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM
imitek
3rd Generation Specific (1993-2002)
9
Aug 28, 2015 05:28 PM
armans
3rd Generation Specific (1993-2002)
5
Aug 15, 2015 09:08 PM



