Front turn signals not working... rears do.
09-15-07, 03:44 PM
#1
This is my social media.
Thread Starter
iTrader: (22)
Join Date: Jan 2006
Location: WA
Posts: 2,744
Likes: 0
Received 0 Likes
on
0 Posts
Front turn signals not working... rears do.
I noticed that ever since I removed my pop-up headlights to install my headlight kit for my FC2000 replica bumper, my front turn signals do not work. The rear turn signals work just fine... thing is the fronts will blink as well when I have the hazards on. The fronts work when the hazards are on, but not when signaling. I replaced the turn signal switch about two months ago and that was not the problem. Anyone had this problem?
09-15-07, 03:52 PM
#2
Rotary Enthusiast
Join Date: May 2007
Location: Canada
Posts: 770
Likes: 0
Received 0 Likes
on
0 Posts
Are they on a fuse? If so is the fuse blown?
On my FB one of my front turn signal didn't work, so I ran a wire from the signal on the back on the same side up to it. That fixed it.
On my FB one of my front turn signal didn't work, so I ran a wire from the signal on the back on the same side up to it. That fixed it.
09-15-07, 11:34 PM
#3
Former Moderator. RIP Icemark.
gotta be a wiring issue,
and I am very skeptical that the hazards work in the front because the Hazards and the rears use the same wire as the front turn signal wire.
So when you put the FC2000 on, how did you wire the parking lights and turn signals? Could you have mixed up the ground?
and I am very skeptical that the hazards work in the front because the Hazards and the rears use the same wire as the front turn signal wire.
So when you put the FC2000 on, how did you wire the parking lights and turn signals? Could you have mixed up the ground?