2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Fresh swap..... rough idle.

Thread Tools
 
Search this Thread
 
Old Nov 4, 2007 | 09:46 PM
  #1  
yella41's Avatar
Thread Starter
Junior Member
 
Joined: Apr 2007
Posts: 43
Likes: 0
From: Saskatoon, Canada
Fresh swap..... rough idle.

Finally got my engine swapped out. Car starts and drives. However it is real rough in the low idle, it will jump from 1000, to 700, and than noise dives until it stalls. I havn't changed the gas yet(could also be old gas) but just in case any ideas. Plugs and wires look soild, timing is good.
Reply
Old Nov 4, 2007 | 10:21 PM
  #2  
Fattony's Avatar
Senior Member
Tenured Member 15 Years
iTrader: (1)
 
Joined: Oct 2005
Posts: 258
Likes: 0
From: NOVA
check for vacume leaks, check again. if you used block off plates make sure you use rtv, and also check your tps
Reply
Old Nov 4, 2007 | 10:53 PM
  #3  
rx74u2nv's Avatar
Junior Member
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 15
Likes: 0
From: SC
Just a thought, when I did my engine swap a few years ago, I couldn't remove all the intake manifold gasket, so I put a new gasket over it and therefore caused a leak. It ran really rough until I fixed the gasket.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
joel(PA)
Group Buy & Product Dev. FD RX-7
8
Oct 4, 2015 06:07 PM
93FD510
New Member RX-7 Technical
2
Oct 1, 2015 02:00 PM
Turblown
Single Turbo RX-7's
1
Sep 30, 2015 05:58 PM




All times are GMT -5. The time now is 01:04 PM.