fixed idle/bac issues>more problems??
#1
fixed idle/bac issues>more problems??
so i finally got the bac and idle issues taken care of... idles rock solid around 800 w/accessories.... no fast idle issues either... but now>>> I installed my Safc to help tune this bay up get some better milage... the ****** want to fall on its face anytime you stomp the throttle.. what i mean is >regular soft driving its fine .. but when you apply throttle more than quarter it stutters... i can be nice to the gas and ride the tac up to about 5000 even 6000 rpm's no prob. but apply some more gas for spirited driing and pfpfpfpfppfpfpfpfpfp.....wtf... so here is the thing safc is hooked correctly no adjustments no fuel added none taken away.... just hooked up.... but it didn't do it before....... so you say ok SAFC... but I've double and triple checked wiring and settings.... tps is new and adjusted perfect.... before the safc it would run like a raped ape... checked all vac lines. checked injectors- wiring- new fuel filter- new plugs -perfect grounding..... the funny thing is my old TII had a similar problem never figured out motor blew oil rings. It flabergasted many people.. never found ... I dare you to figure this one.,....
#3
Rotary Enthusiast
Join Date: May 2004
Location: OC
Posts: 1,088
Likes: 0
Received 0 Likes
on
0 Posts
sounds like something in your safc may not be set right. recheck the settings according to your series of car. did you space the grounds correctly and the right distance apart?
the safc may be faulty too, but first just make sure everythings connected, and what did you use to connect it? make sure you use solder, and NEVER use quick splices.. those things are teh goddamn devil
edit: so you checked your wiring? one more time are the grounds correct. and the only thing left to worry about is the connections you used. use a multimeter to check for continuity of signal from afm to ecu. see if theres any loss
the safc may be faulty too, but first just make sure everythings connected, and what did you use to connect it? make sure you use solder, and NEVER use quick splices.. those things are teh goddamn devil
edit: so you checked your wiring? one more time are the grounds correct. and the only thing left to worry about is the connections you used. use a multimeter to check for continuity of signal from afm to ecu. see if theres any loss
#5
the safc is working properly its set for FL-6 4 cyl and the arrow points up to the right.... added some fuel at idle smoothed the bigger ports at idle..... what I don't get is this motor even ported ran like a raped ape on stock ecu... i added the safc just to help.....???? I'm about to rip the thing out.... also if i un hook the safc at the connector and complete the airflow circuit it should run right.....
see if it still persists...
see if it still persists...
Last edited by astrochild7; 01-09-05 at 04:16 AM.
#7
tps all the voltages look good..... so last night i change the hi lo settings a little and its running great again.......lo 28% hi 50% ??? but no fuel added or taken so why should that matter... its almost like its a loose wire.. may not even be pertainning to SAFC..... before this motor blew, I had a intermitten prob.. just a complete loss of engine power under any throttle... completely random and about once a week... nver found prob.... almost like a loss of ignition for a sec...
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM
Devon300zx
2nd Generation Specific (1986-1992)
15
09-16-15 06:57 AM