To Finish My Swap
02-21-05, 09:58 PM
#1
Rotary Enthusiast
Thread Starter
Join Date: Apr 2004
Location: NJ
Posts: 841
Likes: 0
Received 0 Likes
on
0 Posts
To Finish My Swap
ok i got a engine with a complete engine harness so instead of taking mine part i cut it and took out the motor... then i took out the passenger carpet and disconnect the the 3 clips that go to the ECU and i realized on the new harness there are 2 more clips... there located between the Ecu clips and the firewall (where it enteres the engine bay)... how do i get to them to disconnect it so i could take out the old harness through the firewall and put the new one in?
Last edited by LookThatsMe; 02-21-05 at 10:00 PM.
02-22-05, 01:12 AM
#3
Carter 2.0
I am the only one that thinks this but, you have to take out the blower motor for the A/C or heater. Once this is out you can access the two other connectors without any problem. Cutting the other wiring harness just lost you about $100. What were ya thinkin??
02-22-05, 10:53 AM
#4
Rotary Enthusiast
Thread Starter
Join Date: Apr 2004
Location: NJ
Posts: 841
Likes: 0
Received 0 Likes
on
0 Posts
hmmmm any other sugestions? i dont know what i was thinking i just want this done asap i pay around 3g's for insurance and its been like 2 months that it been sittin in my driveway
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM