2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

a few question's

Thread Tools
 
Search this Thread
 
Old Aug 8, 2004 | 12:37 PM
  #1  
rx7-kidd's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 131
Likes: 0
From: Ormmm
Question a few question's

1) starting in 2ed gear good/bad
2)8500 rpms in 1st
3)red lineing car alot
4)car has 155,xxx miles
5)good compression
6)am i hutring my engine

I was just wonderind if im goning to rune my car and i wnt to take care of it.
Reply
Old Aug 8, 2004 | 01:08 PM
  #2  
WAYNE88N/A's Avatar
Lives on the Forum
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 5,721
Likes: 3
From: Coldspring TX
Do you just like hearing the buzzer go off in every gear or what?

2nd gear starts will just eat your clutch a little faster, because you'll have to slip it more to get her rolling...

155K? Sooner or later one of your 8500 rpm romps are going to "roll" one of the OEM apex seals outta there...

Read a lot of threads here, you'll notice a LOT of problems start after a hard run on high mileage engines. And with 155K on her, I'd guess you have somewhere around .5 mil of apex seal wear to go before you hit limits (I had .3 mil to go when I rebuilt her at 186,000, and I too like to romp, but not at 8500 rpms...)
Reply
Old Aug 8, 2004 | 01:42 PM
  #3  
Peruvianrx7's Avatar
Rotary Enthusiast
Tenured Member 10 Years
iTrader: (25)
 
Joined: Sep 2003
Posts: 1,440
Likes: 0
From: Melbourne, FL
ummm... I heard fc's like to be maltreated but damn.... if you treat your girlfriend the same way u treat your car... give them my number... hahaha just kidding bro... but be a lil more gentle...
Reply
Old Aug 8, 2004 | 01:46 PM
  #4  
Parastie's Avatar
Mountain Rotary Mod
Tenured Member 05 Years
 
Joined: Nov 2003
Posts: 2,411
Likes: 0
From: Freaking Poland!!
This depends on your definition of hurting the car. I will say that your car will not last much longer doing this, but then again at 155,000 miles you need to start thinking about a rebuilt anyway.
Reply
Old Aug 8, 2004 | 07:22 PM
  #5  
rx7-kidd's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Feb 2004
Posts: 131
Likes: 0
From: Ormmm
no i dont do 8500 rpms in first i was just woundering if it will hurt the engine and i dont take it much past 5-6000 rpms and i was just wondering about 2ed gear starts
Reply
Old Aug 9, 2004 | 02:29 AM
  #6  
ilike2eatricers's Avatar
I R SAD PANDA W/O BAW
 
Joined: Nov 2002
Posts: 6,061
Likes: 1
From: bay area
Why would anybody want to start in 2nd?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
_Tones_
Adaptronic Engine Mgmt - AUS
10
May 25, 2021 05:37 AM
Nosferatu
2nd Generation Specific (1986-1992)
7
Sep 5, 2015 02:13 PM




All times are GMT -5. The time now is 09:24 PM.