2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Fender Removal

Thread Tools
 
Search this Thread
 
Old Aug 19, 2002 | 05:04 PM
  #1  
NixxoN's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Apr 2002
Posts: 236
Likes: 0
From: Williams Lake, BC
Question Fender Removal

Trying to get the passangers side front fender off... so far I've got the bolt thats at the top on the inside of the door and the bolts that are directly on top of the fender... I've tried searching but the one answer I found wasn't very descriptive and I honestly couldn't figure out what it meant most cases. As descriptive as possable would be great, tks
Reply
Old Aug 19, 2002 | 05:20 PM
  #2  
Six Rotors's Avatar
Rotary Enthusiast
Tenured Member 15 Years
iTrader: (17)
 
Joined: Feb 2001
Posts: 878
Likes: 0
From: Pluto
You have to remove the inner fender and look toward the front of the car---there you will find 3x10mm nuts which hold the fender to the bumper set plate,also look under the fender where it joins the sill.
Reply
Old Aug 19, 2002 | 07:20 PM
  #3  
banzaitoyota's Avatar
What Subscription?
Tenured Member 15 Years
 
Joined: Apr 2001
Posts: 5,926
Likes: 2
From: Aiken SC USA
AND:
From the wheel opening, look back towards the door, about 1/2 way up. You will see 1 bolt
Reply
Old Aug 19, 2002 | 07:21 PM
  #4  
Aaron Cake's Avatar
Engine, Not Motor
Tenured Member: 20 Years
iTrader: (1)
 
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
There are 5 bolt locations on the fender:
-front inside at bumper (3 x 10 MM)
-top (bunch of 10MM)
-bottom rear near door (2x 10MM)
-door frame (2x 10MM ?)
-front underneath just after bumper (2x 10 MM)

After that it should pull away from the bumper towards the rear. Be careful.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
risingsunroof82
1st Generation Specific (1979-1985)
8
Sep 7, 2015 01:11 PM




All times are GMT -5. The time now is 10:24 PM.