FD pump and gauge pod Q
#1
Junior Member
Thread Starter
Join Date: Jul 2003
Location: Vancouver
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
FD pump and gauge pod Q
I been searching all over town and on the net and have yet to come across a 60mm single gauge pod. Anyone know where I may pick on up rather than jimmy rig a 52mm=>60mm? Also FD pump.. did a little research and havent' came across its hp handling capacity. At what point would it be impractical to use on instead of a walbro. I'm not planning on building a mad HP monster. Just curious when it would not be impractical not to have one modding stage wise. Anyone care to enlighten me?
#3
Full Member
Join Date: Dec 2002
Location: Tampa, Florida/The hill
Posts: 193
Likes: 0
Received 0 Likes
on
0 Posts
www.corksport.com might have them
#4
Lives on the Forum
Use the large gauge sizes - 2-5/8"?  It's a little larger than 60mm, but you can always "shim" the gauge to fit.  My typical method is to use two sides sticky foam tape insulation available from most Home Depot type stores.
FD fuel pump unly gives you like 10-15% more capacity over stock Turbo Ii fuel pump.  You're better off getting the Walbro - yes, the Walbro outflows the stock FD fuel pump.
-Ted
FD fuel pump unly gives you like 10-15% more capacity over stock Turbo Ii fuel pump.  You're better off getting the Walbro - yes, the Walbro outflows the stock FD fuel pump.
-Ted
Thread
Thread Starter
Forum
Replies
Last Post