FD engine in an FC
#1
FD Maniac
Thread Starter
Join Date: Sep 2003
Location: Jacksonville FL
Posts: 698
Likes: 0
Received 0 Likes
on
0 Posts
FD engine in an FC
Ok I read the FAQ and it wasnt much help.
I have a fd motor, turbo, computer basically everything it says I need but how do you put it in the fc? Does anyone make a subframe or anything?
I have a fd motor, turbo, computer basically everything it says I need but how do you put it in the fc? Does anyone make a subframe or anything?
#3
Former Moderator. RIP Icemark.
Originally Posted by rotarynemesis
Ok I read the FAQ and it wasnt much help.
I have a fd motor, turbo, computer basically everything it says I need but how do you put it in the fc? Does anyone make a subframe or anything?
I have a fd motor, turbo, computer basically everything it says I need but how do you put it in the fc? Does anyone make a subframe or anything?
1st. why even bother when a S5 Turbo motor would make about the same HP and it bolts in?
2nd. do you have more money than sense, as even if you had a FD motor, if you sold it, you could pay for the entire driveline replacement from non turbo to turbo in a FC and again it bolts right in. Toss in the fact that you wouldf be fabricating and custom part making to fit a $2500 motor into a $2500 car... and well???
3rd. Check out Teds site if you are dead set on this waste of money and time.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
KAL797
Test Area 51
0
08-11-15 03:47 PM