FC Fuel Sending unit
04-22-10, 09:46 PM
#3
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
I did notice that the tops of the gas tanks are different.
the S4 tanks have a connector already wired to it,The s5 has a Connector that connects on the top of the tank and then runs a patch connector that in turn connects with another connector in front of the Rear wheel well,drivers side area.
the S4 tanks have a connector already wired to it,The s5 has a Connector that connects on the top of the tank and then runs a patch connector that in turn connects with another connector in front of the Rear wheel well,drivers side area.
04-23-10, 06:09 AM
#4
Chad Carson
Thread Starter
iTrader: (29)
Join Date: Nov 2001
Location: South of Nashville TN. USA
Posts: 7,010
Likes: 0
Received 0 Likes
on
0 Posts
thanks, helping a friend and gave him part knowing it would work but wanted to be sure as its been sometime since I messed with an fc
04-23-10, 11:12 AM
#5
Driving RX7's since 1979
iTrader: (43)
Join Date: Aug 2001
Location: So Cal where the OC/LA/SB counties meet
Posts: 6,096
Likes: 0
Received 8 Likes
on
8 Posts
Actually, not exactly. The S4 and somewhat different than the S5's. The S4's have smaller/ more shallow gas tanks, so the mounting stalk and more specifically the length of the arm holding the float is a bit shorter on the S4's. Also, as I recall, the way you connect the sending unit to the underside of the lid is different on a S4 vs S5.
04-23-10, 07:47 PM
#6
Chad Carson
Thread Starter
iTrader: (29)
Join Date: Nov 2001
Location: South of Nashville TN. USA
Posts: 7,010
Likes: 0
Received 0 Likes
on
0 Posts
correct all S4 are the same and all S5.
I was speaking on S5 but your correct. Even mazda list a different part number on them.
Chad
I was speaking on S5 but your correct. Even mazda list a different part number on them.
Chad
