2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

FC 1989: Stalls out after warming up to operating temps

Old Jun 8, 2017 | 10:53 PM
  #1  
rexucci's Avatar
Thread Starter
Can Post Only in New Member Section
 
Joined: Jun 2017
Posts: 1
Likes: 0
From: California
FC 1989: Stalls out after warming up to operating temps

1989 Rx7 fc N/A MANUAL

Been on this site for a while and literally made this account right now hoping someone could help me out.

Recently I changed the primary fuel rail due to heavy rain fall of gas coming out of the fuel pulsation dampener. I replaced the injector O rings, spark plugs, IAC, flushed coolant and replaced. She fired up with ease, after letting it idle about 5 minutes it sounded like it was going to die and I thought it was because it had little gas. In less than a minute of driving to the gas station I let go of the throttle and it stalls out.

A few hours later I come back to the car and try starting it again, I let it idle for 40 minutes without pressing on the throttle, so then i press on the throttle and a few seconds later it stalls out.

Reply
Old Jun 9, 2017 | 10:20 AM
  #2  
roTAR needz fundZ
Tenured Member 15 Years
iTrader: (1)
 
Joined: Aug 2002
Posts: 2,614
Likes: 31
From: Freeland, MI
Are you sure you got ALL the vacuum lines hooked up? Double checked to make sure the clips were on properly and securely on all 4 of the injectors? Replace the gaskets from the intake manifold portions you removed? Adjusted the TPS after it idled for the 40 minutes?
Reply


Thread Tools
Search this Thread

All times are GMT -5. The time now is 09:20 PM.