2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:

Exhaust question...+

Thread Tools
 
Search this Thread
 
Old 10-24-01, 09:05 PM
  #26  
Three spinning triangles

 
PaulC's Avatar
 
Join Date: Apr 2001
Location: Been all around this world and still call Texas home (Ft Worth)
Posts: 554
Likes: 0
Received 0 Likes on 0 Posts
DAMN I nearly choked when I spent little over 700 for my cat and single exhaust. There are easier ways and less expensive ways to get the performance and sound from an exhaust.

And my Bonez cat and N1 gave me 37rwhp
Old 10-24-01, 09:32 PM
  #27  
Senior Member

 
Join Date: Feb 2001
Location: olympia,wash
Posts: 379
Likes: 0
Received 0 Likes on 0 Posts
racingbeat makes a presilencer for the gsl-se[wichever one has the 13b]with the airpipe for 5th&6th port set up.its a few $'s more,i would assume that they designed it to functionproperly.i dunno,check it out.give'em call.this is the same thing that i plan to do,but i am still trying to find someone with this setup so i can listen to it,i am concerned about noise levels.i plan to remove my 5th&6th ports.
Old 10-26-01, 01:37 AM
  #28  
Full Member

 
chrispapas's Avatar
 
Join Date: Oct 2001
Location: northwest Indiana,portage
Posts: 184
Likes: 0
Received 0 Likes on 0 Posts
Lightbulb poor man exhaust

I gutted my 1 and 2 cats no #3cat then went 2in pipe to a y pipe made of 2 in with stock muffs 5 and 6 ports open at 4000 rpms did not have the money to spend on a good system I spent 25.00 on pipe and 15.00 on welding rods .
Old 11-07-01, 01:30 AM
  #29  
Junior Member

 
SilverBullittRX-7's Avatar
 
Join Date: Oct 2001
Location: Placerville
Posts: 11
Likes: 0
Received 0 Likes on 0 Posts
Me and my friend went and gutted all 3 of my cats with a long *** screwdriver and a hammer so i have basically a straight pipe that looks legal, was free of cost, and gave me an amazing increase in rwhp while still opening the 5th & 6th ports. Then right after I had the perfect chance to test it out when i was chased on a 2 lane freeway for about 30 miles at about 130-140MPh by some seriously, seriously pist off faggets in a 97 stock Integra and a tricked out civic because I revved my engine while in front of them. Too ****** bad cops arent around when you need them!! Anywayz, all i need now are mufflers for a nice tone and to relieve the back pressure the stock ones create (which is very little) and then I will be set; cheaper than any suggestion for an upgrade exhaust system that anyone has yet mentioned on here.
Old 11-07-01, 08:17 AM
  #30  
...

Thread Starter
 
Ryde _Or_Die's Avatar
 
Join Date: Aug 2001
Location: Tampa, FL
Posts: 7,539
Likes: 0
Received 0 Likes on 0 Posts
Originally posted by SilverBullittRX-7
Me and my friend went and gutted all 3 of my cats with a long *** screwdriver and a hammer so i have basically a straight pipe that looks legal, was free of cost, and gave me an amazing increase in rwhp while still opening the 5th & 6th ports. Then right after I had the perfect chance to test it out when i was chased on a 2 lane freeway for about 30 miles at about 130-140MPh by some seriously, seriously pist off faggets in a 97 stock Integra and a tricked out civic because I revved my engine while in front of them. Too ****** bad cops arent around when you need them!! Anywayz, all i need now are mufflers for a nice tone and to relieve the back pressure the stock ones create (which is very little) and then I will be set; cheaper than any suggestion for an upgrade exhaust system that anyone has yet mentioned on here.
Shoulda gotten out and beat their ***. If their was too many you let them get out then jump back in your car and run them over. Well thats what I would do
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Ian_D
New Member RX-7 Technical
6
09-06-15 10:38 PM
doritoloco
New Member RX-7 Technical
7
09-05-15 12:41 PM
FührerTüner
General Rotary Tech Support
3
09-04-15 01:41 PM



Quick Reply: Exhaust question...+



All times are GMT -5. The time now is 12:25 AM.