Exhaust port, how to fill?
#1
Assume I'm an Idiot
Thread Starter
Join Date: Jan 2016
Location: Eau Claire, WI
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Exhaust port, how to fill?
Hey all,
I just ordered a Varex Exhaust for my car, with it being proper i am going to get the exhaust tightened up at a local muffler shop here in Eau Claire. (See that hanging exhaust in the pic.)
My question is does anyone make anything or have say a 3d Printer Template for a plate or block for the second exhaust port in the rear bumper? Or an idea of how to get rid of it without replacing the bumper.
Always thought it looked ridiculous on after market bumpers and the stock exhaust is long gone, so no split without custom fab.
Thank you for your input.
I just ordered a Varex Exhaust for my car, with it being proper i am going to get the exhaust tightened up at a local muffler shop here in Eau Claire. (See that hanging exhaust in the pic.)
My question is does anyone make anything or have say a 3d Printer Template for a plate or block for the second exhaust port in the rear bumper? Or an idea of how to get rid of it without replacing the bumper.
Always thought it looked ridiculous on after market bumpers and the stock exhaust is long gone, so no split without custom fab.
Thank you for your input.
Thread
Thread Starter
Forum
Replies
Last Post