View Poll Results: in which way is the best to get rid of my old Rx7 and spare parts?
fire it off of the heights cliff in Falmouth cape cod



0
0%
let it roll into the ocean



1
20.00%
leave it in some random persons front lawn without any tags



1
20.00%
use magic powers and make it disapear



0
0%
sell it or give it away for parts to any takers...(e-mail me, you can have it)



3
60.00%
Multiple Choice Poll. Voters: 5. You may not vote on this poll
engine wont start or turn over
i preformed an engine swap on my 86 Rx7 and now that the motor is in and everything is plugged in. the thing wont turn over, it just makes one click and you then hear the fuel injectors click on...i tested the starter and battery, both are good...checked to make sure the cables are connected well enough, there fine too.
lost and would apprieciate any imput
email: cj25880@aol.com
lost and would apprieciate any imput
email: cj25880@aol.com
Jack the front of the car up.
Put it in neutral
Pull the small wire on the starter off, the one that attaches to a Blade.
Either use a screwdriver or better a piece of electrical wire with both ends bare, touch the blade on the starter with one end and then the other end of the wire touch the large electrical connector on the starter.
The starter should turn over when you did that.. If the car was NOT in neutral .....you won't be writting back on this forum for a while.
Write back with the results.
Put it in neutral
Pull the small wire on the starter off, the one that attaches to a Blade.
Either use a screwdriver or better a piece of electrical wire with both ends bare, touch the blade on the starter with one end and then the other end of the wire touch the large electrical connector on the starter.
The starter should turn over when you did that.. If the car was NOT in neutral .....you won't be writting back on this forum for a while.
Write back with the results.
My car sometimes acts up and will just click once when I try to turn it over or everything seems to die, like it is shorting out or something, I disconnect the blade as hailers said, then plug it back in, usually it starts to turn over right away.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
alphawolff
1st Generation Specific (1979-1985)
17
Nov 17, 2015 05:57 PM


