Engine Problems, Not Blown, But Acts Like It?
Thread Starter
I "lost" my emissions....
Joined: Apr 2005
Posts: 1,764
Likes: 6
From: lillington, nc
ok tested the resistance
Secondarys
both around 5.32
primarys (car off)
front rotor
1.24
rear rotor
(1) infinate i guess
this is done at 20k on the meter
does that sound like a short to you guys or what?
Secondarys
both around 5.32
primarys (car off)
front rotor
1.24
rear rotor
(1) infinate i guess
this is done at 20k on the meter
does that sound like a short to you guys or what?
Thread Starter
I "lost" my emissions....
Joined: Apr 2005
Posts: 1,764
Likes: 6
From: lillington, nc
get this. i wired a spare fuel injector connector from the ecu to the block, and it does the same crap. no difference. so i am at a loss now. i dont know what to think.
Thread Starter
I "lost" my emissions....
Joined: Apr 2005
Posts: 1,764
Likes: 6
From: lillington, nc
geez... i just dropped a wire down my intake, but i got it out after pulling the lim.
any one want a rx7? lol j/k
is there anything aside from the ecu that could trigger just 1 injector?
any one want a rx7? lol j/k
is there anything aside from the ecu that could trigger just 1 injector?
Thread Starter
I "lost" my emissions....
Joined: Apr 2005
Posts: 1,764
Likes: 6
From: lillington, nc
oh by the way guys it was my harness, it had shorted the primary injector power wire, a pressuer sensor wire and my main ground; in case any one searches with the same general issue
Thread
Thread Starter
Forum
Replies
Last Post
cdn
2nd Generation Specific (1986-1992)
14
Sep 10, 2015 06:23 AM
cdn
2nd Generation Non-Technical and pictures
0
Aug 11, 2015 08:59 PM