2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Engine Not Starting, battery is GOOD, What next?

Thread Tools
 
Search this Thread
 
Old Feb 13, 2005 | 06:21 PM
  #1  
lastphaseofthis's Avatar
Thread Starter
My job is to blow **** up
Tenured Member 20 Years
iTrader: (8)
 
Joined: Jan 2005
Posts: 2,903
Likes: 5
From: palmyra Indiana
Engine Not Starting, battery is GOOD, What next?

I just talked to my friend who has my 1988 rx-7 N/a and it wont start. i was told all the lights come on but no turnover, what steps do i take inorder to fix it?
batt is good, i am about to go work on it in an hour, your input is apprecieated.
Reply
Old Feb 13, 2005 | 06:30 PM
  #2  
MIDNFauciUSN's Avatar
Roll FIS green
iTrader: (8)
 
Joined: Mar 2003
Posts: 1,738
Likes: 14
From: Jax, FL
stater issues??
Reply
Old Feb 13, 2005 | 06:33 PM
  #3  
barcode's Avatar
Senior Member
Tenured Member 15 Years
iTrader: (1)
 
Joined: Feb 2003
Posts: 431
Likes: 0
From: Bay Area Ca
If it doesn't turn over it's most likely your started. If it turns over but doesn't catch check the engine fuses located on the drivers side strut tower.
Reply
Old Feb 13, 2005 | 06:40 PM
  #4  
lastphaseofthis's Avatar
Thread Starter
My job is to blow **** up
Tenured Member 20 Years
iTrader: (8)
 
Joined: Jan 2005
Posts: 2,903
Likes: 5
From: palmyra Indiana
ok, thanks, i m goin to find a voltameter asap
Reply
Old Feb 13, 2005 | 06:43 PM
  #5  
Russ-R's Avatar
Full Member
Tenured Member 05 Years
 
Joined: Dec 2004
Posts: 226
Likes: 0
From: Georgia
if it turns and fuses are ok, check if it is getting fuel and check for spark
Reply
Old Feb 13, 2005 | 06:45 PM
  #6  
Project84's Avatar
Open up! Search Warrant!
Tenured Member 05 Years
 
Joined: May 2002
Posts: 3,838
Likes: 3
From: Kicking down doors in a neighborhood near you
9 volts will make the lights come on but won't turn the starter. Are you should the battery is dead? I'd check it with that voltmeter. Both the voltage and the amps.

Has he been doing any kind of work under the hood that would possible cause something to be accidently disconnected?
Reply
Old Feb 13, 2005 | 06:54 PM
  #7  
lastphaseofthis's Avatar
Thread Starter
My job is to blow **** up
Tenured Member 20 Years
iTrader: (8)
 
Joined: Jan 2005
Posts: 2,903
Likes: 5
From: palmyra Indiana
ok i'll do that, and he has been doing work on it a little, but i think it was more on checks fluids hoses and checking for rust( i just got the car), he doesnt think its a batter problem but i m gonna try to jump it, if that dont work, i am glad its parked on a hill, then we'll just pop the clutch, still havent found a voltameter, anyone know the how to test without one
Reply
Old Feb 13, 2005 | 07:01 PM
  #8  
BlackRX7Turbo's Avatar
Senior Member
Tenured Member 15 Years
 
Joined: Jul 2002
Posts: 496
Likes: 0
From: NJ
did you clean the battery terminals?
Reply
Old Feb 13, 2005 | 07:05 PM
  #9  
Project84's Avatar
Open up! Search Warrant!
Tenured Member 05 Years
 
Joined: May 2002
Posts: 3,838
Likes: 3
From: Kicking down doors in a neighborhood near you
Check and make sure its getting fuel and spark before you push it down the hill, cause if it don't start, you'll have to push it up the hill.
Reply
Old Feb 13, 2005 | 07:09 PM
  #10  
lastphaseofthis's Avatar
Thread Starter
My job is to blow **** up
Tenured Member 20 Years
iTrader: (8)
 
Joined: Jan 2005
Posts: 2,903
Likes: 5
From: palmyra Indiana
yes it getting spark and fuel, it was running fine yesterday mornin, i guess wat i am going to do is check the wires that run to the starter. and see if its getting juice, if so, then i will just get a new starter
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
Kyo
2nd Generation Specific (1986-1992)
6
Apr 13, 2019 09:24 AM
befarrer
2nd Generation Specific (1986-1992)
4
Aug 14, 2015 04:18 PM
RCCAZ 1
1st Generation Specific (1979-1985)
5
Aug 11, 2015 07:05 PM




All times are GMT -5. The time now is 12:14 PM.