Emissions removal check valve ???? (searched)
#1
Rotary Enthusiast
Thread Starter
Emissions removal check valve ???? (searched)
Ok so im almost done with my emissions removal/rats nest removal. I noticed that there is still 2 hard lines going across the front of the motor. 1 is for the oil to the turbo and the other goes to the little check valve for the TID. My question is do i need the check valve anymore or can i just cap it off at the TID? If not where do i run the line to? Thanks and i did do a search but found nothing on it. So if there is a thread about it feel free to flame. Thanks
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM