Egr valve location
#2
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,834
Received 2,603 Likes
on
1,847 Posts
its on the rear side of the lower intake manifold.
Trending Topics
#8
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
Piece of cake. Remove it. Lay it on some roofing flashing or thin metal approx .030 to .060 thick. Draw an outline of the EGR valve on the thin metal.
Then cut out the outline of the EGR on that piece of metal. Install that piece of metal b/t the EGR valve and the manifold. It's now blocked off at little cost. Also plug the vacuum line attached to the valve. Done.
Heck, you could lay the EGR on some gasket material and cutout the outline of the EGR on the paper and then install it b/t the EGR and the intake manifold as described above. Just don't cut any hole IN the gasket paper.
Then cut out the outline of the EGR on that piece of metal. Install that piece of metal b/t the EGR valve and the manifold. It's now blocked off at little cost. Also plug the vacuum line attached to the valve. Done.
Heck, you could lay the EGR on some gasket material and cutout the outline of the EGR on the paper and then install it b/t the EGR and the intake manifold as described above. Just don't cut any hole IN the gasket paper.
#9
Moderator
iTrader: (3)
Join Date: Mar 2001
Location: https://www2.mazda.com/en/100th/
Posts: 30,834
Received 2,603 Likes
on
1,847 Posts
Piece of cake. Remove it. Lay it on some roofing flashing or thin metal approx .030 to .060 thick. Draw an outline of the EGR valve on the thin metal.
Then cut out the outline of the EGR on that piece of metal. Install that piece of metal b/t the EGR valve and the manifold. It's now blocked off at little cost. Also plug the vacuum line attached to the valve. Done.
Heck, you could lay the EGR on some gasket material and cutout the outline of the EGR on the paper and then install it b/t the EGR and the intake manifold as described above. Just don't cut any hole IN the gasket paper.
Then cut out the outline of the EGR on that piece of metal. Install that piece of metal b/t the EGR valve and the manifold. It's now blocked off at little cost. Also plug the vacuum line attached to the valve. Done.
Heck, you could lay the EGR on some gasket material and cutout the outline of the EGR on the paper and then install it b/t the EGR and the intake manifold as described above. Just don't cut any hole IN the gasket paper.
funny story, when i smogged my t2 many moons ago, i forgot to put the EGR back on, smog guy forgot too, and it passed...
Thread
Thread Starter
Forum
Replies
Last Post
Tem120
3rd Generation Specific (1993-2002)
4
09-07-15 09:53 AM