eccentric shaft pulley removal
#1
Full Member
Thread Starter
Join Date: Mar 2001
Location: Dix Hills, NY
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
eccentric shaft pulley removal
I'm trying to get the 2 extra pulleys off of the eccentric shaft pulley. I have PS and AC so I have the 2 extra pulleys that are connected via 4 bolts to the main eccentric pulley. Do I need a puller of some sort to get this thing off? Haynes and the factory manual just shows the 4 bolts that connected the 3 pulleys together but doesn't say anything on how to take them off. Thanks
#3
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
Just a reminder. The four hole pattern is not symetrical. The holes will only align in one pattern. You might want to mark the pulleys with some white paint so you have an idea how they align when you go to reinstall them.
#5
Full Member
Thread Starter
Join Date: Mar 2001
Location: Dix Hills, NY
Posts: 240
Likes: 0
Received 0 Likes
on
0 Posts
Well I'm back. I tried taping the pulley with a rubber mallet like you said I even sprayed it with penetrating oil and nothing. The two others pulleys i can spin no problem ( I see what you mean about the holes) but the first on is frozen on there real good. Any ideas? Off topic you guys wouldn't know where I can get hold of the twin scroll actuator and a wastegate actuator? Thanks
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM