Dropping in a jspec.....
#1
pei > caek
Thread Starter
Join Date: May 2002
Location: Mars
Posts: 4,643
Likes: 0
Received 0 Likes
on
0 Posts
Dropping in a jspec.....
Hey, I have a 87 turbo ii with a blown rear rotor. Recently Ive decided to buy a s5 motor, but if anyone would be kind enough to list *everything* needed to put a s5 motor into a s4 body it would be great.
Assuming the s5 motor is a complete long block.
Assuming the s5 motor is a complete long block.
#3
Learned alot | Alot to go
iTrader: (2)
Join Date: Apr 2002
Location: Rotaryland, New Hampshire
Posts: 4,232
Likes: 0
Received 0 Likes
on
0 Posts
motor (of course)
engine harness
ecu
pressure sensor
afm
new gauge cluster if you want the marked redline, but if you dont care, i dont see why you would need to change it
i cant think of anythying else, but id ask more people anyways
-Jacob
engine harness
ecu
pressure sensor
afm
new gauge cluster if you want the marked redline, but if you dont care, i dont see why you would need to change it
i cant think of anythying else, but id ask more people anyways
-Jacob
#6
pei > caek
Thread Starter
Join Date: May 2002
Location: Mars
Posts: 4,643
Likes: 0
Received 0 Likes
on
0 Posts
Would it be possible to swap everything off my s4 block? So basically I would be using the s5 block, turbo, and manifolds? But injectors/sensors/tranny/any other accessory from my current one?
#7
Banned. I got OWNED!!!
You HAVE to swap everything off your s4 block. The s5 wiring and ecu will NOT plug into your cars dash harness. You swap everything right down to the front cover, but keep the flywheel and front counterweight that came on the engine(these are weight/balance specific). Youll be able to drop it in and plug it up this way, and the car will run just like it did before. The other alternative is a NIGHTMARE of splicing and second-guessing. BEsides, you can make a lot o fmoney selling all the s5 t2 stuff. Keep in mind the s5 turbo and manifold are preferred, so you might wanna keep those on the new engine, as well as the intercooler and maybe even intake manifolds, but things like injectors and sensors MUST be swapped, as well as keepig your old s4 throttle body and OMP.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM
pfsantos
2nd Generation Specific (1986-1992)
1
09-30-15 01:29 PM