DankestKush

iTrader: (4)

OK, so long story short i was coming home last night took a glance down and noticed my oil pressure was off the charts. I pull over and check everything and noticed the wire coming from the oil pressure sending unit has been cut/disconnected. I need to know where this wire goes. Its torn after the connector, so im guessing it got pulled from the harness? Looks like it can easily be spliced.

lduley

iTrader: (1)

Its right below the oil filter neck, protrudes out of the rear iron, looks like a knock sensor with a little end on it for the connector

RotaryEvolution

iTrader: (30)

gold bell shaped piece of **** below the oil filter.

jjwalker

That is the finest explanation of the sensor I have ever read!

DankestKush

iTrader: (4)

I know what it looks like I just need to know how to trace back the wiring and where do I reconnect it

jjwalker

its a single wire with a white connecter that slides over the end of the sensor.

It comes out of the large harness running just below.

The wire is Yellow/Red