Downpipe + stock turbo?
12-03-02, 03:06 PM
#3
W. TX chirpin Monkey
Join Date: Sep 2001
Location: Mesquite, TX
Posts: 2,684
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Mr. Eccentric
Creepy.
Creepy.
the DP has to have the same bolt pattern as the turbo. it's a triangular desing. check out www.thunderfabrications.com and they make this crazy DP, MP cat-replacement single piece pipe. All 3" and bolts up to your cat back. It's a good thing you're getting a DP first and not a cat-back. Get rid of your biggest bottlenecks first, and then go from there. IF you need any more info feel free to PM me.
12-03-02, 03:12 PM
#4
**-P I drive a miata.
Thread Starter
Join Date: Jul 2002
Location: albany, GA
Posts: 1,600
Likes: 0
Received 0 Likes
on
0 Posts
The thunderfab was EXACTLY what I was looking at!
I have ported my wastegate past the lip.... so I figure I should be good for 10 psi. I may later port it more and weld a valve to it. SHOULD have gone ahead and done that, but I was pressed for time and I only have an arc welder.
My cats are bad. No emissions checking. Emissions are already shot on this car. Might as well get some xtra power out of it!
I have ported my wastegate past the lip.... so I figure I should be good for 10 psi. I may later port it more and weld a valve to it. SHOULD have gone ahead and done that, but I was pressed for time and I only have an arc welder.
My cats are bad. No emissions checking. Emissions are already shot on this car. Might as well get some xtra power out of it!
12-03-02, 04:41 PM
#5
Check www.corkcport.com You can get the SS mp\dp for a couple of extra $$$!
Thread
Thread Starter
Forum
Replies
Last Post