door latch wont work
#1
3 cars infront of you
Thread Starter
Join Date: Jul 2003
Location: Lewisville, TX
Posts: 226
Likes: 0
Received 0 Likes
on
0 Posts
door latch wont work
my drivers door will not open using the inside or outside handle i used a slim jim and got it open and took off the door pannel, both handles still appear connected is there something else that could be causeing this problem? i dont know if its a common problem on these cars or not i know it is on some other cars like mustangs and 300ZXs anyway any help would be much apreciated.
TIA
TIA
#2
Registered Abuser
Join Date: Jul 2003
Location: Upper Marlboro
Posts: 697
Likes: 0
Received 0 Likes
on
0 Posts
When you have the door panel off watch the two metal poles when you lock and unlock the car from the inside and out. Then watch what happens when you pull the door handle up from outside and inside. They operate slightly differently but similar enough that you should be able to tell if one of the poles is bent to the point that it wont perform its job. I recently had and fixed that problem on my FC. I still haven't fixed the inside door lock but when I got the car all of the poles on the driver's side were so bent neither the inside or outside lock worked and neither inside or outside door handle would work.
#3
I wish I was driving!
Originally Posted by Whitesmoke
my drivers door will not open using the inside or outside handle i used a slim jim and got it open and took off the door pannel, both handles still appear connected is there something else that could be causeing this problem? i dont know if its a common problem on these cars or not i know it is on some other cars like mustangs and 300ZXs anyway any help would be much apreciated.
TIA
TIA
Thread
Thread Starter
Forum
Replies
Last Post