Don't want to break it
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jun 2007
Location: NJ
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Don't want to break it
Trying to remove the sunroof liner so I can unbolt the sunroof shell - reading through here it says "just pull it out/down" I can only pull down the front about 3/4 of an inch and cant feel any clips or anything? also with the roof up it looks like the liner is held in or slid into 3 clips? any advice would be appreciated
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
I just did this.
Open the sunroof a bit.
Reach onto the edge of the sunroof liner and pull down..
Now,there are plastic pin clips in the middle of the sunroof liner,so either move the roof back more or stick your hand in between the Roof and the liner.separate the panel from the metal sunroof.
The last part of the liner slides into a Tab,so after you have the Front and middle off the Sunroof panel,then just pull the liner Forward(towards the front of the car) and it will slide out.
Open the sunroof a bit.
Reach onto the edge of the sunroof liner and pull down..
Now,there are plastic pin clips in the middle of the sunroof liner,so either move the roof back more or stick your hand in between the Roof and the liner.separate the panel from the metal sunroof.
The last part of the liner slides into a Tab,so after you have the Front and middle off the Sunroof panel,then just pull the liner Forward(towards the front of the car) and it will slide out.
Thread
Thread Starter
Forum
Replies
Last Post
Project88Turbo
3rd Generation Specific (1993-2002)
8
08-29-15 02:23 PM