I am currently swapping out my NA rear diff for a T2 rear diff. However, the T2 diff does not have the 3 front mount studs. What would be the best way to remove these studs from the NA to put into the T2 rear diff?

Thanks

 

Put two nuts on one of the studs and the tighten the two nuts against each other so the outer nut is jamming the inner nut on the stud. Then use a wrench on the inner nut to turn the stud out of the differential. Repeat for the other two studs.

 

Thanks RX3SP.

I tried it that way before but I just wasn't putting enough force into it. They broke free this time and I am all set.

Thanks!