diff bearings
Thread Starter
Senior Member
Joined: Apr 2002
Posts: 317
Likes: 0
From: Washington
diff bearings
so im installing my cusco rs finally and my adobe isnt working for some reason so i cant access the fsm on fc3s.org.
i just need to know how to remove the bearings on both sides of the diff so i can swap em over to the cusco. any help is appreciated. thanks
i just need to know how to remove the bearings on both sides of the diff so i can swap em over to the cusco. any help is appreciated. thanks
Last edited by S13 Slide; Apr 9, 2004 at 11:58 AM.
Queer
Joined: Mar 2001
Posts: 742
Likes: 0
From: Formerly in the Ass end of the pacific.
It says to remove the rear bearing with the 46-0636-145 SST
and the side bearing with the 49-0839-425C SST. The side bearing SST just looks like a bearing puller on steroids. The other one is like a vice that goes between the gear and the bearing and then you puch out the gear from the top so the bearing pops off.
and the side bearing with the 49-0839-425C SST. The side bearing SST just looks like a bearing puller on steroids. The other one is like a vice that goes between the gear and the bearing and then you puch out the gear from the top so the bearing pops off.
Full Member
Joined: May 2001
Posts: 90
Likes: 0
From: Forest, Ontario, Canada
I just took a quick look at the FSM, and I would suggest you fix your Adobe and read the stuff around 9-37. There are precise measurements and spacers required to install the diff. correctly. Wish I had the guts to try something like this. Good luck.
Thread
Thread Starter
Forum
Replies
Last Post
