Did I break my BAC?
Thread Starter
Joined: Sep 2002
Posts: 2,000
Likes: 0
From: Orange County, CA
Did I break my BAC?
Well I took out my BAC and when I connected it and put the key to the ON position I could hear a click.
After messing around with it the thing wouldnt click anymore.
Does it mean that I need a new one?
Do the S4 n/a BAC fit the S4 TII?
Thanks
After messing around with it the thing wouldnt click anymore.
Does it mean that I need a new one?
Do the S4 n/a BAC fit the S4 TII?
Thanks
Thread Starter
Joined: Sep 2002
Posts: 2,000
Likes: 0
From: Orange County, CA
when i start it the idle would drop and then die
If I kept my foot on the gas after a while it would idle
Now the car dies no matter how long I let it warm up for.
If I kept my foot on the gas after a while it would idle
Now the car dies no matter how long I let it warm up for.
Joined: Feb 2001
Posts: 29,798
Likes: 128
From: London, Ontario, Canada
There are test procedures in the Haynes and factory shop manual for the BAC. Measure the resistance and make sure it is within spec, then apply (BRIEFLY) a 12V source through a 10 ohm resistor (10W) and make sure the valve moves.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
Oct 17, 2020 03:25 PM