89t295k

Darn it. putting engine together and the little triangles of the als seals are slightly thicker and don't slide into the corner seals. Are they suposed to be forced in...or do they fit loose? Do I file em down or file open the corner seals? The main body of the seals slide right in but those little buggers on the end do not. Thxs.

jsnow82

iTrader: (3)

File down the corner seal until you get the desired spec. They should not be tight. .002-.003 is where I like them. Also make sure to check the apex seal groove and spec that if needed. Good luck!

Jose