custom coolant/radiator plans, questions.
#1
Full Member
Thread Starter
Join Date: Aug 2009
Location: Nashville, TN
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
custom coolant/radiator plans, questions.
I'm swapping a 91 N/A 13b into my miata, and obviously it'd be a good idea to upgrade the cooling at the same time. I'm going to get an aluminum radiator that fits a miata, then hook it up to the 13b. the only issue is that because of the engine bay layout, the radiator will be really far from the engine. I think the best solution is just to weld on some 16 -AN fittings on the radiator and water pump housing and run stainless lines.
However, the top coolant neck on a 13b that goes over the thermostat (the thermostat fits between the coolant neck and water pump housing, right? the engine I rebuilt didn't come with one so i'm not 100%) is made of plastic. am I going to have to fab something up, or did a different generation of rx7 come with an aluminum one that would fit?
thanks.
However, the top coolant neck on a 13b that goes over the thermostat (the thermostat fits between the coolant neck and water pump housing, right? the engine I rebuilt didn't come with one so i'm not 100%) is made of plastic. am I going to have to fab something up, or did a different generation of rx7 come with an aluminum one that would fit?
thanks.