RX7Club.com - Mazda RX7 Forum

2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.
Sponsored by:
Banzai Racing

crankcase pulley timing?

Thread Tools
 
Search this Thread
 
Old 07-15-11, 04:36 AM
  #1  
Full Member
Thread Starter
 
MANSU_V36's Avatar
 
Join Date: Jul 2009
Location: hawaii
Posts: 144
Likes: 0
Received 0 Likes on 0 Posts
crankcase pulley timing?
This maybe a stupid question. I know to my knowledge the answer is no, I just wanna make sure. My question is does spinning the crankcase pulley throw off/adjust the timing?? I ask because I accidentally spun it while trying to put the pulley on. thanks in advance.
MANSU_V36 is offline  
Reply Like
Old 07-15-11, 04:59 AM
  #2  
Rotary Zealot!

iTrader: (8)
 
Derekcat's Avatar
 
Join Date: Jun 2004
Location: Milwaukie, Or
Posts: 1,735
Likes: 0
Received 2 Likes on 2 Posts
The eccentric shaft pulley? It will only go on one way [the 4 little bolt holes are just *slightly* misaligned if you look closely]

Though you do have to turn the pulley to a certain position before stabbing the CAS [crank angle sensor]
Derekcat is offline  
Reply Like
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic Increasing water temp Single turbo with EWP and Vmount
sherff
Adaptronic Engine Mgmt - AUS
9
02-24-19 12:09 PM
Atkins multirib pulley set, worth it?
LunchboxCritter
2nd Generation Specific (1986-1992)
15
01-03-16 04:11 PM
how are we supposed to tune timing on a rotary?
stickmantijuana
Engine Management Forum
11
11-09-15 01:15 PM
Idle/TPS/Timing issue
incubuseva
2nd Generation Specific (1986-1992)
14
09-03-15 12:37 PM
how are we supposed to tune timing on a rotary?
stickmantijuana
20B Forum
10
08-19-15 01:47 PM
Back to Subforum
2nd Generation Specific (1986-1992)
View Next Unread
88 Vert Seat Question




Advanced Search
Quick Reply: crankcase pulley timing?


Reply Closed Thread Share

All times are GMT -5. The time now is 08:20 PM.