2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

crank control sensor

Thread Tools
 
Search this Thread
 
Old Mar 13, 2002 | 04:44 AM
  #1  
86 mazda's Avatar
Thread Starter
Newbie
 
Joined: Mar 2002
Posts: 4
Likes: 0
From: michigan
crank control sensor

this was not even the problemi checked the coils with ohm meter and it said they were good wrong. i took all the plugs out and one by one i put them in the wires and laid the wire with the plug in it and then turned the car over and the leading coils were bad no spark at all. the trailing coils are working great so i bought some coils and now i wait for them to get here and i hope this fixes my problem
Reply
Old Mar 14, 2002 | 02:58 AM
  #2  
Keith's Avatar
Senior Member
Tenured Member 10 Years
 
Joined: Mar 2001
Posts: 501
Likes: 1
From: Lawrenceville,Georgia,U.S.
I hope it fixes your problem also, but your leading coils check may have been invalid. You only have one leading coil, even though it has 2 plug towers. In order to check it, BOTH spark plugs must be grounded to complete the circuit. That means you can check either plug as long as the other plug is installed and/or grounded with the other plug wire plugged on. Otherwise, there is no path between the 2 leading plug towers, and there can be no spark even if there is no malfunction. Good luck!

Irv, Keith's dad
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
stickmantijuana
MoTeC
5
Sep 10, 2015 07:58 PM
EfiniGirl
Haltech Forum
2
Sep 1, 2015 09:31 PM




All times are GMT -5. The time now is 05:21 PM.