Crank angle sensor output?
Thread Starter
Full Member
Joined: Dec 2001
Posts: 189
Likes: 0
From: St. Louis
Crank angle sensor output?
Can some one tell me or send me a pointer to the technical details for the output from the crank angle sensor, and the pin-out for the connector?
Thanks!
Steven
Thanks!
Steven
Joined: Mar 2001
Posts: 31,833
Likes: 3,232
From: https://www2.mazda.com/en/100th/
it has 2 outputs. an Ne and a G signal. they both are the same signal ecept the one is the "home" tooth and the other one is the rpm signal.
i dont remember the pinouts but if you put a voltmeter on it its really easy to figure out.
mike
i dont remember the pinouts but if you put a voltmeter on it its really easy to figure out.
mike
HAILERS
Joined: May 2001
Posts: 20,563
Likes: 27
From: FORT WORTH, TEXAS,USA
There is a factory manual at www.fc3s.org for you car with schematics. I only have a 87 fsm so its not relevant. Might read this while your deciding what to do: http://www.teamfc3s.org/info/articles/demystifying.html Also at www.fc3s.org they have the print out for your ECU pins and the values.
Thread
Thread Starter
Forum
Replies
Last Post
Adaptronic 1280s Hot Start 3 Rotor 20b RX7
Monsterbox
Adaptronic Engine Mgmt - AUS
5
Sep 11, 2015 03:29 PM
