corksport fender fitment pictures
03-14-04, 05:07 PM
#1
corksport fender fitment pictures
here is stock7's car with a fender on one side. You can see some of the fitment issues. Anyone else put these and how did you guys solve the problem. I beleive the solution is simple and i will show a picture of how to solve it.
Last edited by Dltreezan; 03-14-04 at 05:14 PM.
03-14-04, 06:07 PM
#6
Senior Member
iTrader: (1)
Join Date: Dec 2001
Location: Wilmington, NC
Posts: 317
Likes: 0
Received 0 Likes
on
0 Posts
Originally posted by Molotovman
Thats cause you need al the other corksport stuff yo.
Thats cause you need al the other corksport stuff yo.
Mine look like they are going to need serious work to fit around the bumper and doors too.
Trending Topics
03-14-04, 07:08 PM
#13
See if S5 tII side skirts will fit w/that fender. The front piece may cover most of the difference. They're fiberglass, right? I don't know any way the fender could be "pulled " out to match the door line.
May be time for a good bodyshop...
May be time for a good bodyshop...
03-14-04, 07:32 PM
#14
Full Member
iTrader: (2)
Join Date: Feb 2003
Location: central OH
Posts: 135
Likes: 0
Received 0 Likes
on
0 Posts
I'm not sure if rx7s are the same way, but on old American iron there are shims between the fender and rocker where the fender bolts on the bottom of the car. Removing shims will add more bow to the fender allowing the door to open and the body lines to match. Adding shims will remove the bow.
03-14-04, 09:38 PM
#20
Originally posted by jon88se
not only do they fit poorly (which can be fixed fairly easily and should be expected) but they look like crap too
that vent has to go
not only do they fit poorly (which can be fixed fairly easily and should be expected) but they look like crap too
that vent has to go
It's all personal taste..I for one think they look great, although I will be putting some mesh behind them to make it look not so open. I just hope they give me the clearance I need, which I think they should.
