2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

Cooling system - running cold

Thread Tools
 
Search this Thread
 
Old Jan 10, 2004 | 09:16 AM
  #1  
Kai's Avatar
Kai
Thread Starter
Rotorphile.
Tenured Member 05 Years
 
Joined: Mar 2002
Posts: 1,296
Likes: 0
From: Richmond/NoVA
Cooling system - running cold

Over the past few days my car has been running super cold, since I replaced my thermostat and installed a dual alternator pulley. The car is running at 130-145* F according to my guage in the thermostat neck, with the old thermostat it was running at least 160*, and I replaced it to try to get my temps up into the 180* range, and it just made it worse. The car also takes forever to warm up.

I am guessing my brand new OEM Mazda thermostat is sticking open, but is there anything else that can cause the car to run super cold?
Reply
Old Jan 10, 2004 | 09:34 AM
  #2  
HAILERS's Avatar
HAILERS
Tenured Member 10 Years
 
Joined: May 2001
Posts: 20,563
Likes: 27
From: FORT WORTH, TEXAS,USA
I'm assuming I have OEM Mazda thermostats in my cars (I bought them from Mazdatrix), and on short trips of five to ten miles lets say, I can assure you the AutoMeter electric water temp gauge is lucky to get to the 150 mark. That's on these winter days where the temp is from 32 to 45 degrees. On the same day if I take the car out on the interstate and drive at seventy for ten or fifteen miles, then the gauge will get close to the 180 mark, but still just under that. Just my observations and I'm assuming that they are OEM thermostats, don't know for 100 percent certainty.
Reply
Old Jan 10, 2004 | 09:37 AM
  #3  
Kai's Avatar
Kai
Thread Starter
Rotorphile.
Tenured Member 05 Years
 
Joined: Mar 2002
Posts: 1,296
Likes: 0
From: Richmond/NoVA
Yeah, well, when I'm flying down the highway at a happy 80mph for twenty plus minutes the temp guage doesn't break 145*F, even at 50*F outside temps, that's what worrys me.
Reply
Old Jan 11, 2004 | 06:38 AM
  #4  
Kai's Avatar
Kai
Thread Starter
Rotorphile.
Tenured Member 05 Years
 
Joined: Mar 2002
Posts: 1,296
Likes: 0
From: Richmond/NoVA
Anyone else have comments on the problem or want to share normal wintertime temps?
Reply
Old Jan 11, 2004 | 01:15 PM
  #5  
Full Member
Tenured Member 05 Years
 
Joined: Jul 2002
Posts: 97
Likes: 0
From: Calgary Ab. Canada
sorry i don't have a proper temp guage but i never see above a fifth on the stocker all winter long here in calgary, in thge summer i can get a quarter or a third up, i have done some research and no one thinks that having it run really cold all the time is bad, just harder on fuel a bit. if you know otherwise please let me know mine always trakes a long time to warm up too.
Reply
Old Jan 11, 2004 | 01:23 PM
  #6  
SAiamNE's Avatar
Rotary Enthusiast
Tenured Member 05 Years
 
Joined: Aug 2003
Posts: 868
Likes: 0
From: Calgary, AB
As long as its running fine i wouldn't worry about it to much. I think that main reason why they want to to run at that "certain temp" has something to do with emissions and like nathantheman said it will run a little richer causing less fuel milage..
Reply
Old Jan 11, 2004 | 02:09 PM
  #7  
86GXL's Avatar
Rotary ≥* Soul
Tenured Member 10 Years
 
Joined: Dec 2003
Posts: 785
Likes: 0
From: Oregon
I still using the stock guage and it never even moves the whole winter...
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
Feb 24, 2019 12:09 PM
highspeedrider
Introduce yourself
6
Aug 19, 2015 03:44 AM
ncds_fc
New Member RX-7 Technical
1
Aug 15, 2015 10:06 AM
Wolf_
Single Turbo RX-7's
3
Aug 11, 2015 04:23 PM




All times are GMT -5. The time now is 06:34 AM.